6.4.2.1 Connection-Control Plugin Installation

To enable you to configure its operation, the CONNECTION_CONTROL plugin exposes several system variables:

To entirely disable checking for failed connection attempts, set connection_control_failed_connections_threshold to zero. If connection_control_failed_connections_threshold is nonzero, the amount of delay is zero up through that many consecutive failed connection attempts. Thereafter, the amount of delay is the number of failed attempts above the threshold, multiplied by connection_control_min_connection_delay milliseconds. For example, with the default connection_control_failed_connections_threshold and connection_control_min_connection_delay values of 3 and 1000, respectively, there is no delay for the first three consecutive failed connection attempts by a client, a delay of 1000 milliseconds for the fourth failed attempt, 2000 milliseconds for the fifth failed attempt, and so on, up to the maximum delay permitted by connection_control_max_connection_delay.

You can set the CONNECTION_CONTROL system variables at server startup or runtime. Suppose that you want to permit four consecutive failed connection attempts before the server starts delaying its responses, and to increase the delay by 1500 milliseconds for each additional failure after that. To set the relevant variables at server startup, put these lines in the server my.cnf file:

[mysqld]
plugin-load-add=connection_control.so
connection_control_failed_connections_threshold=4
connection_control_min_connection_delay=1500

To set and persist the variables at runtime, use these statements:

SET PERSIST sets the value for the running MySQL instance. It also saves the value, causing it to be used for subsequent server restarts. To change a value for the running MySQL instance without saving it for subsequent restarts, use the GLOBAL keyword rather than PERSIST. See Section 13.7.5.1, “SET Syntax for Variable Assignment”.

The connection_control_min_connection_delay and connection_control_max_connection_delay system variables have fixed minimum and maximum values of 1000 and 2147483647, respectively. In addition, the permitted range of values of each variable also depends on the current value of the other:

Thus, to make the changes required for some configurations, you might need to set the variables in a specific order. Suppose that the current minimum and maximum delays are 1000 and 2000, and that you want to set them to 3000 and 5000. You cannot first set connection_control_min_connection_delay to 3000 because that is greater than the current connection_control_max_connection_delay value of 2000. Instead, set connection_control_max_connection_delay to 5000, then set connection_control_min_connection_delay to 3000.

When the CONNECTION_CONTROL plugin is installed, it checks connection attempts and tracks whether they fail or succeed. For this purpose, a failed connection attempt is one for which the client user and host match a known MySQL account but the provided credentials are incorrect, or do not match any known account.

Failed-connection counting is based on the user/host combination for each connection attempt. Determination of the applicable user name and host name takes proxying into account and occurs as follows:

For the cases just described, the connection attempt matches some mysql.user entry, and whether the request succeeds or fails depends on whether the client provides the correct authentication credentials. For example, if the client presents an incorrect password, the connection attempt fails.

If the connection attempt matches no mysql.user entry, the attempt fails. In this case, no CURRENT_USER() value is available and connection-failure counting uses the user name provided by the client and the client host as determined by the server. For example, if a client attempts to connect as user user2 from host host2.example.com, the user name part is available in the client request and the server determines the host information. The user/host combination used for counting is user2@host2.example.com.

ERROR 1130 (HY000): Host 'host_name' is not
allowed to connect to this MySQL server

To monitor failed connections, use these information sources:

Assigning a value to connection_control_failed_connections_threshold at runtime resets all accumulated failed-connection counters to zero, which has these visible effects: